Nadykto, V., Golub, G., Hutsol, T. et al. Optimization of the parameters of tillage units. Sci Rep 15, 10074 (2025). https://doi.org/10.1038/s41598-025-94769-6
Abstract
Among the many methods and techniques for optimizing the soil-cultivating unit parameters, the method of Lagrange multipliers occupies a special place. In this article, the Lagrange method is used to develop analytical dependencies that make it possible to determine the optimal values of the operating width and operating speed of tillage (ploughing and cultivating) units at a set value of tractor engine power and the linear nature of the dependence of its slipping on traction force. As a result, it was found that the decreasing intensity in the ploughing unit operating width (B) with an increase in the plough’s specific resistance coefficient (Ks) is practically independent of the ploughing depth (h). When changing the value of this parameter in the range of 0.22–0.30 m, increasing the value of the Ks coefficient from 50 to 65 kN m−2 requires reducing the value of parameter B by 23%. The maximum performance of the tractor with the plough occurs at the minimum possible values of the Ks, h and V parameters. This result is achieved by increasing the ploughing unit operating width. At the same time, the maximum performance of the tractor with the cultivator is achieved at the maximum possible values of the Ks (3.6 kN m−1) and V (3.0 m s−1) parameters and amounts to 8.6 ha h−1. Compared to the option for the minimum values of the Ks (3.0 kN m−1) and V (2.0 m s−1) parameters, this is 28.4% more.
Keywords
Performance
Operating width
Operating velocity
Power engine
Tillage depth
Lagrange function
Lagrange multipliers
Scientific Reports has a 2-year impact factor of 3.8 (2023), and is the 5th most-cited journal in the world, with more than 734,000 citations in 2023*. *2023 Journal Citation Reports® Science Edition (Clarivate Analytics, 2024).